search for... WHAT'S NEW! Express Pattern to Unveil an Exclusive NEW SLA Resin Selection Guide for Functional Prototypes at RAPID 2008 Link to Press Release Link to pdf Read About... Our new articles explaining the benefits of Rapid Prototyping to speed the development of your products. Visit our full library of articles and publications.
			Rated Load Fixed Deformation Prototyping Situation Like the Rated Load Mechanical Operation prototyping situation, we simply want to build a part to see how well it performs in normal operation. The difference here is that the component must undergo a fixed amount of deformation (as in a snap fit), not just be able to withstand a load. The objective is not to determine failure loads or life. Key Material Properties The primary material property that controls performance in this situation is stiffness. Since most plastic parts are stressed in flexure as opposed to tension or compression, the appropriate material property is flexural modulus. (To see a comparison of flexural modulus for common rapid prototyping materials, click here) The second key material property is some measure of maximum deformation of the material. There are several to choose from, but elongation to yield is the most appropriate for this situation. (To see a comparison of elongation to break of common rapid prototyping materials, click here) Approximation Requirements How close must we approximate the material properties of an injection-molded plastic to be able to simulate them? We believe that flex modulus must be within 20% of that of the injection molded plastic. That way, deflections will be within 20% of those in actual use. Elongation to break of the SLA resin must be greater than 50% of elongation to yield of the target plastic material. The design typically includes a factor of safety of 2 or more so that occasional overloads will not result in failure. Since in our prototyping situation, loads are limited to rated loads, we do not need to accommodate the design overload. Selection Chart The chart below plots flexural modulus against elongation. Each of the SLA resins we use is plotted as a point on that chart. A shaded rectangle surrounds each point, which represents the range of material properties that that resin can approximate as determined by the approximation requirements above. The chart also includes several common injection molded plastics. If a plastic falls within a shaded rectangle, that resin for this prototyping situation can then adequately approximate it. click here for full view Most common plastics can be simulated by one of the four resin families we run. For a plot like the one above that lists the materials you use in your products, contact Tom Mueller.
			©2008 - Express Pattern, Inc.